Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

failover from active to standby call server(cvp) taking long time.

Hi all

We have 2 vxml gateways pointing to 2 vxml servers.The servers are in active and standby as configured on vxml gw.When vxml1 is taken out of the network it takes 9 to 10 sec for the new calls to get connected to vxml server 2.This is the case with welcome prompts (micro-apps) as well as the application prompts.Is there any ways by which we can reduce this time.Also attached is the configs on the vxml gw1.

1 REPLY
Green

Re: failover from active to standby call server(cvp) taking long

Your dial peers are a bit strange. You have

"session protocol sipv2"

but why don't you say

"session target sip-server"?

I'm not saying it won't work without that statement, but I always use it.

You could also turn down the sip-ua on other retries:

retry response 2

retry bye 2

retry cancel 2

Regards,

Geoff

157
Views
0
Helpful
1
Replies