03-04-2009 01:30 PM - edited 03-14-2019 03:45 AM
Hi,
I get the following error message when I try to add a new JTAPI Trigger (Right next to the DN I added):
"Could not update the user on the CallManager"
Thanks.
03-10-2009 05:43 PM
There may be problem in any one trigger. Remove the defective trigger and route point and create new trigger.
03-11-2009 01:47 AM
Check if this DN is being used before, or not deleted well from the system.
Confirm by adding another DN should pass without any issue.
Regards,
Ahmed Rizk
08-31-2009 09:48 PM
I recently received this error. It was caused by the jtapi and rmjtapi users being misconfigured.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide