There are 10 user defined variables (columns) to use in the ContactCallDetail table (CRS ver 4.0 adn above - only five user defined vars pre4.0 release). You can define a "report variable" in your script and use the "Set Enterprise Call Variables" (General tab) to write the value of the your variable to the user defined - named Call.PeripheralVariable1 thru Call.PeripheralVariable10. (If you are running CRS pre4.0 release, use the Set Session Info step and define the value and var under the second tab.) For example, define a var named ReportVar1 - set some meaningful value to ReportVar1 then, using the Set Enterprise Call Info step (or the other), write it to the table.
Then just query the ContactCallDetail table in the CRA database (to get table layout, refer to the Database Schema manual).
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...