Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Historical Reports not showing Dequeued calls

Is there a reason calls would not show in historical reports under the CSQ by interval report even though I've confirmed that calls were placed to the trigger?

Running UCCX 8.5 . Calls during off hours are re-routed to a different extension via time of day routing. I've verified that calls were placed to the trigger, and that they are routed to the new number, but they are not showing up in historical reports.

Any ideas? I thought they would show up dequeued. I've verified the dequeue function is in the script prior to the redirect.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Historical Reports not showing Dequeued calls

Might seem obvious, but are the calls actually queued in the first place? They will not show as dequeued unless they are queued first!

Brian

4 REPLIES
Silver

Historical Reports not showing Dequeued calls

Might seem obvious, but are the calls actually queued in the first place? They will not show as dequeued unless they are queued first!

Brian

New Member

Historical Reports not showing Dequeued calls

Your right. They are not being queued. It skips them altogether.

Would they not still show as presented? They are trying to analyze the amount of calls coming in during off hours to justify another FTE.

What report would track this? Should I queue the call and then route based on time of day?

Silver

Historical Reports not showing Dequeued calls

Try running an application report. This will show the number of calls presented and you can run this for off hours. The only problem is, if you have different opening hours for callflows within the same application, you won't be able to seperate them out.

In this case try the following options :

- make use of the custom call variables (and then run a custom call variable report). plenty of threads on this here, have a search.

- create a separate application for transferring out of hours, and transfer the call from your main application to this for reporting purposes.

I suppose there's nothing stopping you queuing the call and then dequeuing based on time of day - if it's the only time you dequeue calls then should give you accurate counts

Brian

Please rate helpful posts!

New Member

Historical Reports not showing Dequeued calls

Thanks for your help Brian. The application summary is adequate for our use.

745
Views
0
Helpful
4
Replies