Re: How can i restrict the Out bound campaighs to use some ports
No i am not getting any accept option before that itself the call is getting disconnected as soon as the reservation call comes in my Cisco IP Phone(7940) and it just disconnects in 2-3 seconds ,again the second reservation comes and so on..this issue i have observed in the peak time in my call center where the vulume of incoming calls are higher..
meanwhile could you answer the first Question as well. thanks
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.