Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

How to change UCCX IP Address(HA)

HI All,

I have 2 UCCX Server running HA Mode, I know howto change UCCX IP address for single node but

I'm not sure about HA, Is there any special things that I need to do for changing IP Address in HA Mode?

Regards,

Tinnakorn

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: How to change UCCX IP Address(HA)

Hi Tinnakorn,

Assuming that you are asking w.r.t UCCX 7.0,

Refer to :

Cisco Unified CCX Administration Guide, Release 7.0(1) :
http://www.cisco.com/en/US/docs/voice_ip_comm/cust_contact/contact_center/crs/express_7_0/configuration/guide/uccx70ag.pdf

Pls follow the steps mentioned under section "Modifying Unified CCX IP Address Information (Page 327).".

Run postinstall.exe to configure ur CAD tp point to new IP address of CCX nodes.

And then, you are done. Its pretty simple and similar to the one that you know regarding modifying address for single node. But here, you need to perform this for all nodes.

Hope this clarifies. Good luck.


Regards,
Soman Nair.
(Pls rate if this helps)

1 REPLY
New Member

Re: How to change UCCX IP Address(HA)

Hi Tinnakorn,

Assuming that you are asking w.r.t UCCX 7.0,

Refer to :

Cisco Unified CCX Administration Guide, Release 7.0(1) :
http://www.cisco.com/en/US/docs/voice_ip_comm/cust_contact/contact_center/crs/express_7_0/configuration/guide/uccx70ag.pdf

Pls follow the steps mentioned under section "Modifying Unified CCX IP Address Information (Page 327).".

Run postinstall.exe to configure ur CAD tp point to new IP address of CCX nodes.

And then, you are done. Its pretty simple and similar to the one that you know regarding modifying address for single node. But here, you need to perform this for all nodes.

Hope this clarifies. Good luck.


Regards,
Soman Nair.
(Pls rate if this helps)

5231
Views
5
Helpful
1
Replies
CreatePlease to create content