Not sure I understand the question. First what version are you talking about? Second, if this is 8.x then the first node is "always" the PUB regardless of whether it is master or standby. This is by design.
If the subscriber is the Master you will see that all services EXCEPT the database services are set to "M". On the first node the database services will show to be "M" for that node even though the rest of the services are set to "S".
Both servers are still in sync and the data is the same. This is simply a relationship design.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...