Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to configure Gennic for router?

I have installed UCCE 9.0. How do I install and configure gennic NIC for the router? The gennic.exe process shows state start pending and waiting. When I go in config manager - > nic explorer and try to add nic I dont see the gennic type there. I only see available NIC as in the attached screenshot.

Events from August 31, 2012:

15:54:33:695 ra-nica Initializing Event Management System (EMS) Library.

15:54:33:696 ra-nica Trace: EMS Server pipe ucc9\RouterA\nicaEMSPipe enabled for ucc9\RouterA\nica

15:54:33:697 ra-nica Initializing Node Manager Library.

15:54:33:697 ra-nica Generic NIC process initializing.  Release 9.0.1.0 , Build 1447.

15:54:33:698 ra-nica Trace: Monitor Server pipe ucc9\RouterA\nicaCmdPipe enabled for ucc9\RouterA\nica

15:54:33:702 ra-nica Trace: EMT I/O completion ports: max threads=4, concurent threads=0

15:54:33:710 ra-nica Trace: MBufLimitMgr OpenMutex Global\MBUF Limit Table Mutex

15:54:37:307 ra-nica Connection to MDS process established.

15:54:37:311 ra-nica Trace: Elective Overload control file not loaded

15:55:03:860 ra-nica MDS is in service.

15:55:03:874 ra-nica INRCEngine (DeviceID=5000) CONFIGURE_NIC_RESP error.  error=1

15:55:13:851 ra-nica INRCEngine (DeviceID=5000) CONFIGURE_NIC_RESP error.  error=1

15:55:23:852 ra-nica INRCEngine (DeviceID=5000) CONFIGURE_NIC_RESP error.  error=1

Everyone's tags (2)
1 REPLY
New Member

How to configure Gennic for router?

After speaking to Steve Hartman, I found that Nic is not needed for ICM CIM integration. So ignoring that error.

520
Views
0
Helpful
1
Replies