Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

how to reduce the agent reserve time

We have the setup of HIPCC 7.0 and CVP 3.1 and CCM 4.1, we observed that agent reserve time is going high atleast 12 seconds. if anyone knows how to reduce this reserve time, work around to fine tune it. please advise ASAP.

6 REPLIES
New Member

Re: how to reduce the agent reserve time

Hello,

I suppose you are talking about reserved time in reports.

When an agent is offered a call, that agent is being reserved. So, ringtime (which defaults to 12 seconds) equals reserved time, as the agent is not available for other tasks.

You probably do not want to change the ringtime too much.

HTH, please rate helpful posts.

--bas

Re: how to reduce the agent reserve time

How about using auto answer on their phones? That will probably bring it down to a half to a full ring. If your agents do not have auto answer it might be in their best interest to let the phone ring as long as possible without invoking RONA.

david

New Member

Re: how to reduce the agent reserve time

Hi All,

do you mean that webview reports include the ringtime in reserve time?

because sometimes we are getting 12 secons and most of the time 4 secons 8 seconds. like this kindly clarify it. or advise me which document i can refer....

New Member

Re: how to reduce the agent reserve time

Prakashj,

Yes, ringtime is included in reserved time.

You have two options;

1) Interpret the reports with the knowledge that ringtime is included in reserved time (which is normal).

2) Define autoanswer for your agents to reduce ringtime/reserved time as David suggested.

--bas

New Member

Re: how to reduce the agent reserve time

Dear Bas,

Thanks for the information, if possible provide me document where cisco refer this point, since i have to give explanation to customer.

with Regards,

Manivannan

New Member

Re: how to reduce the agent reserve time

Manivannan,

Check this document, page 57, check the "Reserved" explanation.

http://www.cisco.com/en/US/docs/voice_ip_comm/cust_contact/contact_center/enterprise_reporting/reporting7_0/user/guide/ipce70rg.pdf

HTH, please rate helpful posts.

--bas

281
Views
5
Helpful
6
Replies