Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

I failed UCCX ver8 HA setup.

Dear all,

I installed UCCX first node first and add second node at server, and uploaded license, assinged app admin from CUCM user.

After doing post installation, then I did second node installation.

I went through post installation of second node.

When I run Replication wizard, I couldn't see pre-popluated clster IP address, so I typed by myself.

I finished the wizard, but I saw the error message mentioned that Replication is failed.

If someone knows the reason or solution, kindly share the knowledge.

Warm Regards

Everyone's tags (3)
1 REPLY
Cisco Employee

Re: I failed UCCX ver8 HA setup.

You cannot manually add the primary IP of the primary server on the second box. It should get populated.

When you were installing the second node did you make sure if that server was able to ping the primary box ?

Regards

Anuj

500
Views
0
Helpful
1
Replies
CreatePlease to create content