Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
VIP Purple

Incoming Calls

Hi All,

I need to increase the number of rings on Agents phone before it gets transferred to next available agent.

Currently, after 3 rings call gets transferred to next agent.Is it possible to do so?

regds,

aman

7 REPLIES
New Member

Re: Incoming Calls

Hello Aman,

Yes, this is possible. You need to change the 'Ring no answer time' parameter in the desksettings for those agents.

Agents need to login again to receive the new settings.

HTH

--basv

VIP Purple

Re: Incoming Calls

Hi Basv,

Do we need to change this setting in CAD?

Is these any other way since we do not have CAD installed on Agents desktop?

regds,

aman

New Member

Re: Incoming Calls

Aman,

What CC solution are you using exactly?

--basv

VIP Purple

Re: Incoming Calls

Hi,

We are using CRS Standard 5.0(2)_Build064

aman

New Member

Re: Incoming Calls

In that case, IIRC, you need to adjust the timeout parameter when you select the agent for the call. I'm more used to UCCE nowadays, maybe someone else can confirm this.

New Member

Re: Incoming Calls

That is correct. In your script, on the "Select Resource" step, you will need to adjust the Timeout parameter. It currently defaults to 10 seconds which is approximately 3 rings.

New Member

Re: Incoming Calls

Hi,

Take a care, if your agent's phone have a call forward (voice mail or someting else) this timeout must be smaller than the time out for busy or non answer on your CUCM

regards

Farid

157
Views
0
Helpful
7
Replies
CreatePlease to create content