Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Installing Dbworker

Hi,

I need to enable Dbworker on our ICM 7.2 SR 4 which was recently upgraded from ICM 7.0 SR4. Does this mean that i will need to uninstall the patches and re-run the setup to enable Database Routing and then re-install ICM 7.2 SR4 again?

I would appreciate a quick response on the above.

Thanks

Mohsin kazi

1 ACCEPTED SOLUTION

Accepted Solutions
Green

Re: Installing Dbworker

I understand your concern - running 7.0 setup and "adding" a component after ICM has been patched. But you would not do this from the CD - you would run ICMSetup.exe from the C:\icm\bin directory, edit the Call Router and check DB Lookup.

Do you have a lab system to check this in before applying it to production. If not, why not? ;-)

Regards,

Geoff

3 REPLIES

Re: Installing Dbworker

No, you should be able to re-run setup and just install the dbworker on the rogger.

david

Community Member

Re: Installing Dbworker

Can i run the ICM 7.0 Setup and edit the router config to enable dbworker, with ICM 7.2 SR 4 installed

Green

Re: Installing Dbworker

I understand your concern - running 7.0 setup and "adding" a component after ICM has been patched. But you would not do this from the CD - you would run ICMSetup.exe from the C:\icm\bin directory, edit the Call Router and check DB Lookup.

Do you have a lab system to check this in before applying it to production. If not, why not? ;-)

Regards,

Geoff

398
Views
0
Helpful
3
Replies
CreatePlease to create content