Re: Installing new Unity 5.0(1) and my customer has exchange 200
A mixed mode environment is possible. The following are considerations:
1) VMOnly is not supported (currently) on Exchange 2007.
2) UM is proven functional in Exchange 2007.
If you want to have a single Unity server and a mixed mode environment, use class of service to determine the message store (2007 for UM and 2003 for VMOnly).
I, unfortunately, was not able to do this because our exchange environment is new and we went native 2007. Because the environment is all 2007, 2003 cannot exist in the same domain. Unity can talk to a mailstore in a separate domain, but cannot talk to 2 separate domains.
Depending on the number of servers you wish to deploy, there is always the separate unity box/separate domain option, with both servers talking to the other through VPIM.
is what I used to recreate the sync....but when I do it from primary server it says the secondary server is not a publishing server so it cannot pull anything from it......actually I have done lots of config changes in secondary server and now want the primary to replicate em and work.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...