Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IP IVR 4.0(4) - Initial Setup Fails

I am not sure if anyone has run into this before but during the initial configuration for CRS (IP-IVR configuration) everything seems to work fine until I click the "next" button on the "System Parameter Configuration" page. Basically what happens is the the system goes to the "Please wait while system parameters are saved page" and then it refreshes to a blank page and stops processing; according to the documentation it is supposed to go to the user configuration but it does not. If anyone else has experienced this and knows what is going on any help would be appreciated.

OS 2000.4.4sr2

CRS 4.0(4) - IP IVR installation

1 REPLY
New Member

Re: IP IVR 4.0(4) - Initial Setup Fails

This has been resolved; though I am not sure what the issue was. After about an hour the setup was able to continue on to the next page without issue.

95
Views
0
Helpful
1
Replies