We have just switched from using g.711 to g.729 codec on the network. This have caused some problems for me since i used a recording / vmail script on the ivr's that attached the recorded message and sent it to an email address. Now when we use g.729 the message cannot be played back in windows due to the codec g.729. Is there a way to override the codec in a script only so it can be g.711 for that session? The pc environment does not allow codecs to be installed on them. I use CUCCH + IVR 5.X
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...