Does anyone know, is there any way to manually switch over the IPCC Express server from running on ACTIVE to run on STANDBY?
The idea is, we don't want to run both server concurrently. We want to use IPCC-ACTIVE for 3 month (for example) then put it offline for maintenance purpose and make IPCC-STANDBY to run as an active for this service.
What type of maintainence you want to perform, IPCC servers configured in HA environment are automatically managed.
If you reome the active server the secondary server will automatically take place of primary. you can just shutdown primary server in off peak hour and secondary will take up all services within seconds.
Which service should i stop on control center? (There are many service in control center)
I used to have a problem, that while running one of the service "Cisco Desktop License and Resource Manager Service" fail and the IPCC did not failover to STANDBY server. I don't know why it's failed. I think maybe it's run for too long. So we decided to manually switch only run one server at a time.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.