Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IPCC Enterprise 6.0

Hi,

We are deploying IPCC Enterprise 6.0 duplexed setup at our CU with following components,

Component Version

CallManager 4.1(3) SR3c

IP-IVR 3.5(3) SR3

ICM 6.0 SR9

CTIOS 6.0 SR4

During our initial testing it has been observed that PG visible interface failute takes almost 3 minutes to switchover to other side PG.We would like to know whether this failover time is standard one or is there any scope of improving the same.

Regards,

Tanmay D.

91-9892555229

1 REPLY
New Member

Re: IPCC Enterprise 6.0

I think the PG failover due to network disconnect between PG and Central controller takes something like 50 to 80 seconds.

122
Views
0
Helpful
1
Replies
CreatePlease login to create content