I'm trying to put together a script that will give customers an expected wait time while they're in the queue. I've got this part working but the script reports expected wait time in seconds and I would like for it to report in minutes. I found some post that explained how to do this but it is not working for me and I was wondering if someone could take a look at my script and tell me where I'm going wrong. I realize I still need to add a few things to the script but I mostly want to get the expected wait time working first. Any help is greatly appreciated!!!
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...