I have an Unified CCX Premium 5.0(2)SR01_Build053 with 80 seats out of which 20 are for outbound. I have created a CSQ's, resource group's only for outbound.
And here is the problem. When I connect 20 or 20+ outbound agents and I turn on the outbound campaigns only 10-12 agents are in talking at a certain time. If I reboot the CCX system it works ok for a certain time (couple of hours or a day) and then it comes back to only 10-12 agents of the 20 being used. Agents will stay in the ready state even 2 minutes before being reserved by the system.
Does anyone have an idea? Is there a table where I can see the agents that are used by the outbound subsystem at a certain time ?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.