I am trying to configure remote monitoring on CRS 4.0.I have connected agent desktop & phone on different port (& vlan)on the switch.I want supervisor to do remote monitoring without span configured on the switch.
I have configured rmon.aef. prompt works fine asking for the ext no to be monitored but when I enter the ext no it
What could be the problem??
some doc says nic card should support .1q.Is this required even if i connect agent desktop & phone on seperate vlan & port on the switch??
It appears you are having an issue with the NIC on the PC performing the monitoring for CAD supervisor desktop (if I understand correctly). CAD has known issues with certain types of PC NICs when it comes to this subject. There's a tech note to assist in testing and validation of NIC interoperability with CAD monitoring that may be helpful.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.