I am setting up an ipcc hosted labs in my vmware system.The version of my icm is 7.2.Here is what i have done.
1 Configured 2 facilities a nam and a cicm.
2 I have installed Nam and Cicm as per the Hosted installation and configuration guide version 7 in the same vmware system as its just a lab environment.
Based on the configuration given you are suppose to select the Remote ICM under the system configuration Tab.Here when i select Remote ICM it gets changed back to custom gateway and i am not able to save it as remote icm.(Same for NAM as well as Cicm).Any idea how to turn this on.
My process in the cicm (incrpnic) shows online but shows 0 NAM.I have attached the snapshot.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...