We have IPCC 7.0 (SR4) geographically distributed setup for resiliency. The Rogger, Agent PG, IP IVR, CCM are distributed across 2 different sites.
Currently there are 2 PG's (PG1 - CCM & IP IVR PIM's, PG2 - MRPG) installed in the Agent PG Servers at both sites. The MR PG is currently out of Service and we are not in a position to start the service currently, but we do not want to remove it either.
Since PG2 is not in service, we are facing problem that the Router failover (to Router B) does not work. We understand from previous postings that installing Dummy PG is the solution to resolve the IPCC resiliency issue.
The question is ...is there a limitation from Cisco that the maximum number of PG's which can installed per server is 2..?.Can we install the 3rd PG on the same physical server (Agent PG), since we have the MR PG out of Service, we can install and start the 3rd PG ( Dummy PG) which we believe will resolve the resiliency issue. Will Cisco come back saying that this is an un-supported configuration..?.
We have busy call routers and other servers in the setup and hence any other systems in the current setup cannot be considered for Dummy PG installation.
Have you considered disabling the PIM on PG2 and starting it so that it connects to the router so you have 2 PG's connected? Then when you are ready just enable the PIM on PG2. This would save installing a 3rd dummy PG.
Whether you can have 3 PG's or not on a server will depend on the specification of the hardware. A dummy PG would not take up much processor or memory as it would not have a PIM enabled.
SIP traces provide key information in troubleshooting SIP Trunks, SIP
endpoints and other SIP related issues. Even though these traces are in
clear text, these texts can be gibberish unless you understand fully
what they mean. This document attempts to br...
Please find the attached HTML document, download and open it on your PC.
This provides an easy to use form where you simply answer a few
questions and it will render the proper jabber-config.xml file for you
to copy/paste. There is built in logic to verif...
CUCM Database Replication is an area in which Cisco customers and
partners have asked for more in-depth training in being able to properly
assess a replication problem and potentially resolve an issue without
involving TAC. This document discusses the bas...