Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

IPCC/UCCX wrap-up time automatic work

if automatic work is enabled can the agent interrupt the "Work" state after a call to force themself into Not Ready? I can't seem to find an answer for this question, the customer would like the agents to be able to override the automatic work timer if they need more time.

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Super Bronze

Re: IPCC/UCCX wrap-up time automatic work

While in a Work state, an agent does have the option for going Not Ready as long as they do so prior to the timeout expiring.

2 REPLIES
Silver

Re: IPCC/UCCX wrap-up time automatic work

You cannot configure a wrap-up delay for an agent in Customer Response Solutions (CRS) versions prior to CRS 4.0. This is a new feature which is introduced in CRS 4.0. There is a work-around to allow the Aagent to automatically have a delay before accepting the next call. To do this, modify the IVR script as shown:

On the Interactive Voice Response (IVR) script you are using to route the calls from the queue to an agent, find the Select Resource Step and change the Connect property to No.

Under the Select Resource Step you modified, there is a Selected step. Add a Delay step (The time should be the wrap-up time you want to configure. For example, 30 seconds), and then a Connect step.

Verify in CRS AppAdmin that all Integrated Contact Distribution (ICD) resources have Automatic Available set to Enabled.

Verify in CRS AppAdmin that all the ICD Contact Service Queues (CSQs) have Automatic Work set to Disabled.

This is the expected behavior of the agents:

The agent ends the previous call and goes into Ready state.

The agent is selected to accept the next call, and the agent is put in a Reserved state.

The IVR script hits the 30 second delay. This gives the agent 30 seconds in the Reserved state.

After the delay ends, the call is routed to the agent.

VIP Super Bronze

Re: IPCC/UCCX wrap-up time automatic work

While in a Work state, an agent does have the option for going Not Ready as long as they do so prior to the timeout expiring.

4474
Views
0
Helpful
2
Replies
CreatePlease to create content