Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IPCCX CAD is very slow.

Hi,

I am facing a very strange porblem on IPCC Express.

Version: Cisco Application Administration - 4.0(4)SR01_Build029

Package: IPCC Express Premium

Problem Definition:

CAD is very slow an launch. It takes at least 4-5 min to launch after agent login.

Also change in the state (eg. from work to ready etc) is very slow.

When tried to logout from CAD , it takes 5-6 min to logout.

This is happening on CAD of all the agents configured in the IPCCX.

Need urgent help.

Thakns,

HemantW

2 REPLIES
Silver

Re: IPCCX CAD is very slow.

In a slow network flow, the amount of time a single large (for example, 1500-byte) packet consumes on the network (and delays subsequent packets) can exceed 100 ms. This delay would cause the apparent loss of one or more heartbeats. To avoid this situation, a smaller Maximum Transmission Unit (MTU) size is used by the application for low-priority traffic, thereby allowing a high-priority packet to get on the wire sooner.MTU size for a circuit is calculated from within the application as a function of the circuit bandwidth, as configured at PG setup.

Silver

Re: IPCCX CAD is very slow.

Sounds like you may be hitting CSCsh02642 "CAD Logins and state changes severely lagged".

From the bug notes, a workaround seems to be to restart the Call/Chat service.

This is fixed in 4.0(5)SR1.

Please rate helpful posts.

165
Views
0
Helpful
2
Replies