Hi, does somebody know how to implement a record step without nescesary saking to caller to press somthing to terminate his record ? I know that is working on IPCX 3.5, but on IPCX 4 I can do that ? Does somebody know how to do that ? Do you a a good script example ?
I received an update on my TAC case yesterday stating that an engineering special will be made for 4.0(1)SR1 and it should be available by about January 10th. If you're not familiar with that term, an engineering special is a special patch or pre-release fix available only by request through TAC, instead of regular download from the cisco.com website. It will also be fixed in 4.0(3)SR1 when that becomes available. I'll follow up here with feedback on the 4.0(1)SR1 ES when I get it, so any interested parties can then inquire with TAC.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...