Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IPCX4.01 change G.729 to G.711

Hello folks.

If I wish to change the codec from G.729 to G711 on IPCC Express 4.0.1 do I just need to re-run setup?

Cheers,

NJ.

3 REPLIES
New Member

Re: IPCX4.01 change G.729 to G.711

Hi,

Yes you have to re-run the setup again.

Regards

Srikanth

Re: IPCX4.01 change G.729 to G.711

I assume re-running setup will delete my prompts or will it keeps the scripts, rmcm configuration, jtapi configuration, etc? Or is this like doing a new install, have to re-configure everything?

Blue

Re: IPCX4.01 change G.729 to G.711

Jason, you will not have to reconfigure anything but I would definately recommend taking a BARS backup before starting the reinstall to be safe. I have even gone so far as to take screen shots of each configuration page but thats cuz I am paranoid ;)

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=IP%20Communications%20and%20Video&topic=Contact%20Center&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1ddb7dd7

adignan - berbee

99
Views
5
Helpful
3
Replies
CreatePlease to create content