Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

IPIVR using the record step - recording does not continue for transfer or conference but call is active

We have a simple application where when when an agent dials a route point it starts recording right away.

If the route point is conferenced or transfered to the conference or the transfer happens but after that no voice is getting recorded.

In debug mode I see the rrcording is not being interrupted because of the conference or transfer to the recording route point.

Is there any MIVR log that will help why no recording after the conference or transfer? Will MRGL cause an issue here.The call is active in the real time reports on the 4.1 IPIVR.

1 REPLY
Silver

Re: IPIVR using the record step - recording does not continue fo

You don't say what you are using as a conference bridge.

Check the codec is not changing when you go to the conference. Press the i button on the phone twice quickly to see the codec type.

CCX/IP-IVR only supports G711 u-law

Graham

173
Views
0
Helpful
1
Replies
CreatePlease to create content