Issue upgrading IPCCx 3.5(1) to 4.0(4) - Historical Data
I did an upgrade of a 3.5(1) system to 4.0(4)SR1 and ran into a bit of a problem. The upgrade completed and the system is running but SQLServer was consuming most of the CPU and the system was running terribly slow. We assume the system was busy converting the Historical data and found that by stopping the Historical 3.x datastore, the CPU load went down. We had left the system alone for a couple hours with Historical 3.x running and it did not complete.
This is a single server cluster so it is running MSDE. We did also replace the server hardware as part of the upgrade. The new server is HP DL380 with 3GB of memory.
At this time, the system is running fine with the Historical 3.x datastore stopped. I?m wondering if we can just start it up again over the weekend to see if it completes. Alternatively we are willing to loose the old data. Can I simply remove the Historical 3.x datastore?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.