Can anyone please provide me the procedure to change the Purge settings of an ICM logger 7.x ? i.e. In ICM, we have a log called "Router log viewer"where we will get all call related information. We want to purge these logs on regular interval. Any help would be highly appreciated
We are running the contact center version 7.2. In the ICM there is a log called "Router log viewer" We would like to Purge this log on a regular interval. Say every 15 days, the old logs should be purged automatically. I'm not sure whether we can Purge this particular log alone or we have to Purge the entire HDS logs. Please let me know if you want more information.
In the ICM there is a log called "Router log viewer" We would like to Purge this log on a regular interval. Say every 15 days, the old logs should be purged automatically. I'm not sure whether we can Purge this particular log alone or we have to Purge the entire HDS logs.
I was actually looking into the Router Log Viewer today, because I was seeing more errors there ("No default route for DN") than I was seeing in the dumplog of the router, and I was wondering where the Router Log Viewer got it's information from.
I believe it is looking at either the t_Event table or the t_Application_Event table - according to the schema this is a subset of t_Event.
This table is only on the central controller. I'm guessing that the Router Log Viewer is getting a direct SQL connection to the Logger and pulling the data. Does anyone know more about how the app works?
If my guess is correct, you could control the retention time on the t_Event table to affect what the Router Log Viewer shows. The default is 14 days, so it won't go back further than that.
You cannot purge the whole lot every (say) 15 days as you ask. You could wind this down to (say) 3 days to only have a small number of events.
The Router Log Viewer indeed gets its data out of the above two tables. The Router Log Viewer only pulls certain MessageIds relevant to calls. Some examples that will get you a listing of routed calls and the common 'No default label ..' :
select * from Application_Event where MessageId = '-519765950'
select * from Event where MessageId = '1627914338'
As already mentioned, this is an invaluable troubleshooting tool and you really shouldn't be touching that data. Still, you could change the retention settings as Geoff pointed out. This is the doc on that :
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...