Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Logger services failed

Hi,

The environment include ICM Enterprise 4.6.2.at duplex mode.

Suddenly week ago the services at LoggerA are shutdown.

I receive the following message at the replication service:

"12:43:00 la-rpl Connection to MDS process established.

12:43:00 la-rpl Trace: MDS: Entering MDSAllocBuffer

12:43:00 la-rpl Trace: Call to MDSAllocBuffer failed.

Last API Error [-519815424]: Attempt to use MDS API function before calling MDSRegisterClient.

12:43:00 la-rpl Trace: MDS: Output thread started."

I;m trying to synchronize between LoggerB and LoggerA used icmdba but with no success.

Any idea? How I solve the problem?

Thanks

2 REPLIES
New Member

Re: Logger services failed

There are a number of Tech Tips under Contact Center Software that discuss many of the MDS exhausted messages.

- 1st, was there anything else in the log like

Buffers exhausted? If so see the tec tips for

that.

- 2nd, have your NIC bindings changed? This is a logger you'll have two NIC cards in it (private/public) make sure your going out the proper interface of each card.

- 3rd, We have seen this type of problem with NIC teaming enabled on servers in a load balance mode. If you are don't, it's not supported. It causes out of order messaging.

-4th if you haven't resolved it. Open a Service Request with TAC.

Regards,

Bob

New Member

Re: Logger services failed

Hi,

Thanks for your help but i'm already fixed this problem.

I re-create Logger database using "icmdba".

After i building the database again i synchronize the LoggerA database with LoggerB database.

Thanks

302
Views
0
Helpful
2
Replies
CreatePlease to create content