we have two sides of IPCCE with CVP 3.1 (H323), side B is the active one when we start side A the system goes down and the CVP gives message that time out waiting for ICM instruction, but as soon as I stop the VRUPG of any side the system works fine every thing is setuped OK public and private link are saperated, this happen during the peak hourse only, but during off-peak when there is few calls the two VRUPGs works fine, I notice that the MDS proces on the active side gives an error that (MDS message sync delay exceeded 3000 ms) when and this message keep apearing until I stop the newly activated side,
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...