I'm trying to configure 2 additional searchable fields (metadata) in Cisco QM. I did this a while back but can't figure out what is wrong this time around. The following was done.
a) IVR script sets the enterprise data to the standard callvar1 & 2
b) Create 2 ipc action (tag & metadata) in desktop workflow where custid & acctno is assigned with callvar1 & 2 respectively. Assign the ipc action to answered & dropped event. Also created 2 task button to trigger the ipc action manually.
c) Define the 2 fields (custid & acctno) with proper field type in QM admin user define metadata
d) When agent answers the call, callvar1 & 2 is displayed accordingly in CAD
e) Call was recorded accordingly but custid & acctno metadata field is always empty. Triggering the ipc action manually through the task button also resulted in the same outcome.
Did I miss out some configuration to make this work?
We experienced something similar to this when our agents would hang up first. We found that by letting the caller disconnect the call, then the metadata would appear. We were also able to get the metadata to appear by adding another button, but I can't remember what the action was for it. Our agents found it cumbersome and decided to just let the caller hang up first.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...