I've now made progress and found out the CSS on the CUCM for the CTI ports was incorrect and couldn't make outbound calls to the phone number I was testing against ... so now I can log in.
Unfortunatly I now find that MA works if I am in a ready state, but if the calls gets queued via the IPIVR 7.0 server then the call gets dropped when the agent goes ready and a transfer is initiated to the agent. The IVR CTI ports seems to have the correct CSS so I'm a bit confused about this one, more debugging required.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...