I have new UCCX 9.0 server and I want to listen the calls between my call agents and the customers silently. I know its possible but unfortunately I am not getting any step by step article to perform this.
In order to listen to agents in CAD. Go into CCX>Tools>User Management>[Select Subscriber to be assigned Supervisor Privs]
Click on the Subscriber, scroll down to the bottom in "Available Capabilities". Select "Supervisor". Then click the left arrow butto to move into "Selected Capabilities".
Scroll up and click Update.
Open Supervisor desktop
Select a team from the drop down.
In the "Agents" window (bottom left) click to expand "Agents"
Look through the list of agents on a call. Click to highlight the agent on a call in progress
At the top under the "Menu" you will see icons. The "Start Voice Monitor" icon should be in color. Click on it. You'll now hear the discussion in progress between the agent and the customer. The agent will not see you or hear you listening in. The customer will not hear any audible tone alerting them you are on the call.
To configure desktop based recording and monitoring .Complete these steps:
Make sure that the Agent/Supervisor phones have SPAN TO PC PORT set to enabled.
Make sure that the Advertise G.722 Codec option in the enterprise parameter menu of the Cisco Unified Communications Manager is set to Disabled, as UCCX Desktop Monitoring does not support the G.722 codec.
The agents extension should be Unique on Call Manager, as the lines that are going to be monitored or recorded cannot be shared lines.
Make sure that Windows Firewall is disabled on the Agent/Supervisor Desktops.
Launch PostInstall.exe from the C:\Program Files\Cisco\Desktop\bin folder on the agent PC. This should have the correct IP address of the NIC card that the PC is using. If the PC is using two NIC cards, one of them should be disabled. Desktop monitoring does not work if teaming is enabled on the NIC cards.
NIC binding should have the NIC used to record the first one at the Agent and Supervisor PCs. Right-click on My Network Places, select Properties > Advanced > Advanced Settings, and the recording NIC should be the first one in the Connections field. If not, move it to the first position, and reboot the PC.
The phone should be a daisy chain. For example, PC > IP Phone > Network.
The Recording Count must not be set to ZERO. Complete this step in order to ensure this is not the case:
From the Cisco Unified CCX Administration page, go to System > System Parameters, and set the number of the recording count appropriately.
On the UCCX server, complete these steps:
Note:- Recording and monitoring will not work in wireless NIC card so make sure u have wired NIC
And if you have symantec antivirus then make sure its disabled .
If you have configued above steps correctly then i am sure recording and monitoring will work properly .
From the Navigation bar, choose Cisco Desktop Administrator.
Go to Services Configuration > Multiline, Monitoring and Recording > VOIP Monitoring Device, make sure that the default Monitor Service is selected, and Desktop Monitoring is enabled for each agent.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...