Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

MTP Resources

Hi,

Is there anybody know how to check the utilization of Software MTP and IOS MTP. I know how to check the utilization of hardware MTP. but i didn't get any command or way to check the utilization for the Software and IOS MTP.

  • Contact Center
2 REPLIES
Green

Re: MTP Resources

The RTMT (Real Time Monitor Tool) connected to your CUCM cluster can show the MTPs - total number, number in use, number left etc. as time passes. Very useful.

Regards,

Geoff

New Member

MTP Resources

So I know this is an old post, but to do my part to keep information in one place, I'll ask my question here.

I need to allocate more MTP resources for my CUCM cluster. I am planning on utilizing my 3945 voice gateways by setting up DSP farms and registering them with CUCM (version 7.1.5). I am leaning towards utilizing the actual DSP hardware as the majority of my call traffic in this site will be via SIP trunk and each router has a single PVDM3-192.


So my question is...what happens if all of my DSPs are in use as MTP resources for the SIP traffic? Is there any negative affect on the router? Can I set a limit on the router so that I can keep some DSP channels free for TDM calls? What if I decide to set up software only MTP resources on the router. From what I've read, these only utilize the router CPU. If that's the case, how would I limit those MTP resources so that I am not over taxing the router CPU?

Thanks!


Brett

822
Views
0
Helpful
2
Replies