Multiple PAT sessions overloaded on WAN can't connect VPN Server
I have problem in VPN connectivity with PAT overloading. Can anybody suggest what could be the issue?
I have a 2800 Cisco router. I have done PAT with Public WAN IP for entire private LAN Pool. LAN users are dialing a Public VPN server and not able to establish the VPN. One thing I have noticed that very first connection to the Server is being established but the second connection from the LAN is not getting through... It looks like VPN server is accepting only one connection from a Public source IP. Since I am PATing, so always my source is same.....
But I have done another test by using a very low end home use WIFI router and done the PAT... It's working with this router. I am able to connect multiple LAN PC with VPN Server.....
Do I need to put some special commands on my CIsco router which would allow multiple TCP connection to the VPN server?
Note :- 1.No VPN config in router. VPN client is installed at each PC.
2. VPN Server is a public server and I don't have the management access.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...