Hi. I have read the document of IPCC Ent installation, where i found the below points.
"When installing IP IVR for use with IPCC Enterprise, be sure to select the ICM option during installation".
i want to know where to select the ICM option. what i understand is, if we want IP IVR for enterprise environment, we have to install a IPCC express in which we can select IVR option and make as a child to ipcc enterprise. But in the IPCC enterprise environment, we will be getting the IPIVR software along with ICM softwares? or it is the same IPCC EXPRESS IVR software only? pls explain.
Because i installed IPCC Express 4.1 premium edition with IVR license, where i could not find the ICM option in the SUBSYSTEM tab.
Hi Corey. Thank you once again.Pls keep answering to the questions.Which is very helpful to lot peoples. That too the way you answer to question is nice. You answer question by questions. So that the person who asked the questions can understand it clearly.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.