Re: Need to move around "Not Ready" codes in CAD Agent
That question has been asked before, and the answer was that it was not possible.
You cannot issue a request to change the not ready reason code without changing state to "not ready", and if you are in the "not ready" state, issuing the request to go not ready is most probably turned into a "no op" by the state machine on the server side.
You could use dynamic reskilling, remove the agent from their skills, go ready, go not ready with reason, then put the skills back - but what a crock that would be.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.