Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

New Site Install

A new site Install consists of majorly 3 steps

1. Adding the PG configuration in PG Explorer

2. Run the Router setup to enable DMP

3. Run ICM setup in PG

However I wanted to check in Step 1 and Step 2 interchangeable ?

What is the recommended flow and what are the issues in not following the sequence.

Thanks

Alok

1 REPLY

New Site Install

Doesn't really matter PG doesn't become active until all steps are done.

david

134
Views
0
Helpful
1
Replies
CreatePlease to create content