Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Outbound Option Multiple Dialers Configuration

Hi,

Here is my setup:

Duplex MRPG with 2 Pims connected to 2 Dialers. Each dialer has 30 ports.

My question is, how do I configure the Campaign if I need to use all the ports from both Dialers (2x30) for a single campaign?

Do I have to create 2 Skillgroups and associate them with the dialed number from each dialer?

Is there any way to setup a single campaign to use 1 skillgroup and use 2 dialers?

Regards

Erwin

2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: Outbound Option Multiple Dialers Configuration

Outbound option will automatically use all available dialers on the same peripheral as the skill groups configured for the campaign. Whatever dialed number string you configure for the skill group in campaign settings, you will need to configure that dialed number for each of the two dialer routing clients and associate both dn's to the same script.

New Member

Re: Outbound Option Multiple Dialers Configuration

Yes, it is expected behaviour.

Campaigns will dynamically seize ports as needed, based on the number of agents available, and the number of calls they need to make. Calls seem to the dialler connected to the first MR PIM, and then overflow onto the second.

We currently have 2 x 96 port diallers, and the second dialler only makes calls when the first dialler is maxed out. If you have multiple campaigns, you can configure the dialled numbers to be on only one MR PIM, to provide dedicated capacity for each campaign - although any campaigns sharing the same dialler will dynamically share those ports.

Also, it is recommended practice to separate the diallers onto separate CM subscribers to balance the dialling load.

Regards,

Corey.

5 REPLIES

Re: Outbound Option Multiple Dialers Configuration

Outbound option will automatically use all available dialers on the same peripheral as the skill groups configured for the campaign. Whatever dialed number string you configure for the skill group in campaign settings, you will need to configure that dialed number for each of the two dialer routing clients and associate both dn's to the same script.

New Member

Re: Outbound Option Multiple Dialers Configuration

Thanks ed,

I will test this and hopefully this should be ok.

regards

Erwin

New Member

Re: Outbound Option Multiple Dialers Configuration

Ed,

Thanks for that. it's working. However, the Campaign Manager will only use the first Dialer first and then if all ports on Dialer1 have been used it will then use Dialer2.

Is this the expected behaviour?

New Member

Re: Outbound Option Multiple Dialers Configuration

Yes, it is expected behaviour.

Campaigns will dynamically seize ports as needed, based on the number of agents available, and the number of calls they need to make. Calls seem to the dialler connected to the first MR PIM, and then overflow onto the second.

We currently have 2 x 96 port diallers, and the second dialler only makes calls when the first dialler is maxed out. If you have multiple campaigns, you can configure the dialled numbers to be on only one MR PIM, to provide dedicated capacity for each campaign - although any campaigns sharing the same dialler will dynamically share those ports.

Also, it is recommended practice to separate the diallers onto separate CM subscribers to balance the dialling load.

Regards,

Corey.

New Member

Re: Outbound Option Multiple Dialers Configuration

Thanks Corey.

Yes, I have registered both Dialers to 2 different subscribers.

Regards

Erwin

171
Views
0
Helpful
5
Replies