Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Overflow Queue in Outbound Agent-Based Campaigns

Hi everyone.

I've been given a requirement to have a blended outbound campaign overflow to a queue in predictive or progressive mode.  This would happen if an agent is dialing 4 lines at once, and two callers pick up.  Rather than dropping the second caller, they should be routed to a queue until a blended agent is routed the call.

I've been told that an IVR-based campaign can accomplish this, but I don't have enough ports in CVP to be able to Send to VRU for each one.  Therefore, I'm wondering if there is a way to do this using Agent-Based campaigns and only transfer to the VRU for queuing treatment when necessary. 

The closest thing that I have been able to find is within the skill group configuration for a campaign, there is a field that says "Route points for transferring to an IVR" and one of the options is "When no agents are available."  Would plugging in a directory number for a route point work there, or is this field not what it sounds like and totally off-base for what I'm trying to accomplish? 

Thanks!!

Everyone's tags (2)
2 ACCEPTED SOLUTIONS

Accepted Solutions
Bronze

Re: Overflow Queue in Outbound Agent-Based Campaigns

You're right on the money there James. Configure a number under the "When no agents are available" section as you mentioned, then configure a CTI route point in CUCM, associate it with the pg user, create the Dialed Number for it in UCCE and then go abouts setting it up as a normal inbound type call flow (remember to translation route) etc.

Cheers,

Nathan

Re: Overflow Queue in Outbound Agent-Based Campaigns

One thing to note, is your CVP port count, if by any chance you get a lot of people answering your calls and you're dialing 4 calls at once, you will get 3 calls go to the IVR and might run out of CVP ports very quickly.

david

3 REPLIES
Bronze

Re: Overflow Queue in Outbound Agent-Based Campaigns

You're right on the money there James. Configure a number under the "When no agents are available" section as you mentioned, then configure a CTI route point in CUCM, associate it with the pg user, create the Dialed Number for it in UCCE and then go abouts setting it up as a normal inbound type call flow (remember to translation route) etc.

Cheers,

Nathan

Re: Overflow Queue in Outbound Agent-Based Campaigns

One thing to note, is your CVP port count, if by any chance you get a lot of people answering your calls and you're dialing 4 calls at once, you will get 3 calls go to the IVR and might run out of CVP ports very quickly.

david

New Member

Re: Overflow Queue in Outbound Agent-Based Campaigns

Thanks guys!  Will give this a try.

434
Views
0
Helpful
3
Replies