Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PG install help!!

IPCC Enterprise 7.0sr3

I am in the process of rebuilding a simplex PG server and have the 1st component of the instance built (PG1a), but can't seem to get the CTI server component done. When running icmsetup, I select the instance, then click add on the components, but everything is grayed out and unselectable. I'm hoping I am just missing something simple, but can't seem to get past this point. I am a member of the ICM_Setup and ICM_Config security groups, so rights should be taken care of. From the docs I have found, everything starts with adding this component from icmsetup, but I can't get there from here...

any assistance would be greatly appreciated.

2 REPLIES
New Member

Re: PG install help!!

Yep, just me having a "duh" moment. I was running icmsetup off the machine itself, which only gives you edit ability on the components already installed. Once I used the CD again, no problems.

New Member

Re: PG install help!!

Are you rebuilding some components on a sprawler and running the setup locally ? Run the setup from the CD ?

122
Views
0
Helpful
2
Replies
CreatePlease login to create content