PG PIM config view in UCCE without stopping process

[Michael Grachev]

Hey everyone!

Does anybody know how to view configurtion of previously configured PIM (in case of cucm PIM - cucm ip address, jtapi user and so on...) ?

I know that we can do it in Peripheral Gateway Setup via choosing component and pushing Edit button. But it requires the process to stop, that is not very good in production.

Is there any way to view it without stopping PG process ?

Thank you.

BA,

Michael

[Gergely Szabo · Accepted solution]

Hi,

sure, if you know what you are looking for, it's in the registry. For instance:

HKLM\SOFTWARE\Cisco Systems, Inc.\ICM\\PG1\PG

G.

[vinodkewate · Accepted solution]

You can check above configuration parameter via registry editor in PG.

Below is the path for CUCM/JTAPI related config,

Start-->Run-->Regedit-->HKEY_LOCAL_MACHIN-->SOFTWARE-->Cisco System,Inc-->ICM-->UCCE_Instance-->PGXX-->PG-->currentversion-->JGW-->jgw1-->JGWData-->Config

You can view all your configuration related CUCM PIM here.

[Michael Grachev]

Awesome!

Thank you.