PG service unable to start and automatically shutdown the PG server
We have ICM 6.0 with 5 cluster simplex PG setup... We plan to upgrade next month... but today we have issue with one of the PG server... When we try to start the ICM service, after 5mins the error pop-up shows "icm node manager manager shutting down system. to cancel shutdown, run the 'stopshut' utility.
Please refer the error message attached and advise me on the same..
Re: PG service unable to start and automatically shutdown the PG
Thanks a lot your suggestion.. I have checked and found CPU utilization is reached 100% due to unknown exe file “
svhost.exe”. Due to high CPU usage ,ICM PG services are unable to start.
Please find the CPU utilization screen capture attached for your reference. Normally windows application will use “svchost.exe”, but we observed here “svhost.exe” is running “99%” and we are suspecting this could be Virus.
informed to our windows team to check this issue.. once CPU issue fixed i'll check the PG service and keep you posted..
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...