Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

PG1A vrupim in Activating state

Hello

My PG1A VRUPIM is in Activating state and I can see in the vrupim process '' Attempting to connect to VRU at IP of ICM port 0. Please find the enclosed file.

Could you please any suggest me how should I solve this issue?

And , Where should I configure port no?

1 ACCEPTED SOLUTION

Accepted Solutions

PG1A vrupim in Activating state

Hi Suryanarayana Chintu,

Please provide the correct VRU connection port on the VRU PIM configuration. Definately it is not zero as in your case.

By default it is 5000. You can crosscheck this by logging into your IVR admin->Subsystems->ICM->VRU connection port.

Please dont forget to rate the helpful posts (by clicking on the starts below each answer and select appropriate starts).

Hope it helps.

Anand

2 REPLIES

PG1A vrupim in Activating state

Hi Suryanarayana Chintu,

Please provide the correct VRU connection port on the VRU PIM configuration. Definately it is not zero as in your case.

By default it is 5000. You can crosscheck this by logging into your IVR admin->Subsystems->ICM->VRU connection port.

Please dont forget to rate the helpful posts (by clicking on the starts below each answer and select appropriate starts).

Hope it helps.

Anand

PG1A vrupim in Activating state

Given IP address as IVR IP and port no 5000, now its acive. thanks

316
Views
0
Helpful
2
Replies
CreatePlease to create content