Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Phone problems after upgrade from 8.5 to 9.0

Hi everyone,

I upgraded our UCCX cluster last week from 8.5 to 9.0, and ever since then I've been getting reports of delays when answering a call (up to ~10 seconds). I also have one user that reports not being able to hangup at the end of a call (has to wait for the customer to terminate the call). Any ideas?

CUCM Version: 9.1.1.20000-5

UCCX Version: 9.0.2.11001-24

Also, I have ran the JTAPI resync to ensure that wasn't the issue.

  • Contact Center
4 REPLIES

Phone problems after upgrade from 8.5 to 9.0

That's very strange, did you confirm the firmware version on the phones?  What type of phones?

david

Cisco Employee

Re:Phone problems after upgrade from 8.5 to 9.0

Any workflow on anwered event in cda might cause this..


Sent from Cisco Technical Support Android App

New Member

Phone problems after upgrade from 8.5 to 9.0

Thanks for the input guys, but it ended up being a weird problem resulting from extension mobility. When I upgraded the cluster, I forgot to deactivate extension mobility, and this apparently confused CUCM. Our agents use extension mobility in order to allow for moving between physical phones and IP communicator, and the CDA records showed call transfers from the CCX being routed through the subscriber (which is at a remote WAN site) before reaching the phones using extension mobility. Deactivating the service on the entire cluster, rebooting the cluster, and then reactivating the service fixed the issue.

Phone problems after upgrade from 8.5 to 9.0

Very strange, thanks for following up though.

david

248
Views
4
Helpful
4
Replies
This widget could not be displayed.