Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem to migrate UCCX 5.0 to another CCM (7.01)


Do somebody know how to integrate UCCX to another CCM? I used CRS serviceability utility to change all stuff and I recreate the same CRS admin account on my new CCM. But When I/m trying to log in, I have the message "Unauthorized", as it's not the right account or it's not a CRS admin...

If I tried to use CRS admin utility, it didn't want to launch.

Hall of Fame Super Silver

Re: Problem to migrate UCCX 5.0 to another CCM (7.01)

You can use CET tool and chnage the state to "FRESH_INSTALL" which will allow you to go through the initial wizard again.

1 . Start the Config Object Browser.

Go to start -> run and type "cet"

(or run cet.bat in the "C:\Program Files\wfavvid" directory )

2 .Select "" from the config object type tree and double click on the row at the right pane.

3 . Select the "" tab and change the Setup State from "DONE" to "FRESH_INSTALL".

4 . Restart the node manager.

5 . Login to the Appadmin with Administrator/ciscocisco credentials.

6 . This will lead to the initial setup page.

HTH, please rate all posts


New Member

Re: Problem to migrate UCCX 5.0 to another CCM (7.01)

Thanks Cdren, it's not completely solve my problem.... During this new install I need to put Licence files. I use a VMWare for our course and it was installed before with an USB key. So, no license file!!! Do you have a solution to recover this Licence file or to put another one?

I went to but it is impossible to generate one for UCCX

Thanks again

CreatePlease login to create content