Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

"Could not update the user on the CallManager"

Hi there,

I'm trying to add a JTAPI trigger under Cisco Script Application. I get the following error message:

"Could not update the user on the CallManager"

I hope someone can help me to reslove this issue.

Thanks in advance.

Regards,

Sana

1 REPLY
Bronze

Re: "Could not update the user on the CallManager"

You may try performing the following steps:

1)Check the CiscoMIVR log, find whether the JTAPI was in partial server due to a route point in oos.

2) IF one of the trigger was not functioning remove the non-functioning trigger. Remove the route point in oos in CallManager.

3) Add CallManager publisher's Ip address in the JTAPI provider's list.

4) Restarted the Engine. JTAPI is now in full service.

Add a new trigger from the CRS server.

Hope this helps.

559
Views
0
Helpful
1
Replies