Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Realtime statistics for Wallboards for UCCX 8.0

For our client we have developed 2 Wallboard pages for UCCX 8.0 based Contact Centre, both the pages do a database dip every 2 secs.

Main Screen: Details on this screen is captured from RtCSQsSummary Table

Pic1.jpg

Agent Status Screen: Details on this screen is captured from Resource / AgentStateDetail / ResourceSkillMapping / Skill  Tables

Pic2.jpg

We have observed that the data seen on the Main Screen- Agent Status is not in sync with the data seen on the Agent Status Screen. If a State of the Agent changes on the Agent Status screen to Ready, the number of Ready Agents on the Main Screen is not reflected immediately. It takes almost 10-12 secs to reflect the changes on the Main Screen. We have checked the data by accessing the Database directly using Squirrel, the RtCSQsSummary table data takes longer to reflect the changes seen in the AgentStateDetail Table.

Does anyone know why the data in the RtCSQsSummary table takes longer to refresh than the AgentStateDetail table, is there any configuration which controls this?

1 ACCEPTED SOLUTION

Accepted Solutions
Super Bronze

Re: Realtime statistics for Wallboards for UCCX 8.0

Hi

The rtCsqSummary table and the other rt table should update in accordance with the settings configured in 'Tools/Realtime Snap Shot Config'. Check that the interval there is set to 5 seconds as the default is 30.

If it is set to 5 and isn't updating properly, it's probably TAC-case-time.

Aaron Harrison

Principal Engineer at Logicalis UK

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
3 REPLIES
Super Bronze

Re: Realtime statistics for Wallboards for UCCX 8.0

Hi

The rtCsqSummary table and the other rt table should update in accordance with the settings configured in 'Tools/Realtime Snap Shot Config'. Check that the interval there is set to 5 seconds as the default is 30.

If it is set to 5 and isn't updating properly, it's probably TAC-case-time.

Aaron Harrison

Principal Engineer at Logicalis UK

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
New Member

Realtime statistics for Wallboards for UCCX 8.0

Many thanks Aaron,

We will double check this and speak to TAC.

Regards,

Kiarash

New Member

HI, nice wallboard, can you

HI, nice wallboard, can you share your query of your report definition for this wallboard.

Thank You

1752
Views
0
Helpful
3
Replies
CreatePlease to create content