Just wanted to replace an existing jtapi provider IP address with a new one. This is the 2nd IP after the comma (,) that I want to replace. I'm not sure what's going to happen after putting the new IP address and hitting the "Update" button. Never done that before.
Are there any things that I need to be aware of before doing this? Could you please share your experience? Thanks in advance.
You're right about my CCX version. I assume the User Prefix (under the JTAPI>JTAPI Provider) and the User ID (under the RmCm>RM JTAPI Provider) will not be affected after the IP address at those places got replaced. Just wanted to confirm.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.